1.

fit over existing hood
Simply unfold the shade-a-babe and place over the hood/canopy of your pram or pushchair. The curved out design on the top section allows for the use of the ‘window’ feature found on many pushchair canopies.

2.

secure Velcro® fastenings
The two Velcro fastenings attached to the top section of the shade-a- babe should be secured around the handlebars. The Velcro fastenings found along the side of the shade-a-babe can be secured in one of two ways: Either (a) wrap around the side bars of the pushchair and secure back onto the Velcro tabs sewn on to the
shade-a-babe, or (b) join the Velcro pieces around the back of the pushchair and fasten together.

3.

cut Velcro® to correct length
For safety reasons, excess Velcro must be cut off and discarded.

4.

adjust the length to fit
If necessary, the length of the lower mesh can be shortened to fit. Simply fold the bottom section of the mesh underneath and secure with the Velcro fastenings.

5.

to use the SINGLE model as a half shade
simply unzip the central panel and fold mesh into built-in pocket.